Main Menu
Your Cart

NCY Compression Spring 1000 RPM (Vino, Zuma 125)

NCY Compression Spring 1000 RPM (Vino, Zuma 125)
NCY Compression Spring 1000 RPM (Vino, Zuma 125)
NCY Compression Spring 1000 RPM (Vino, Zuma 125)
NCY Compression Spring 1000 RPM (Vino, Zuma 125)

Description: Compression springs do a couple of things. First, they supply the pressure to engage the belt. They also determine the rate at which the CVT transmission changes from low to high gear. A 1000rpm spring will go into a higher gear sooner than a 2000rpm spring. This NCY 1000 rpm compression spring is specifically for the Yamaha Vino 125 & Zuma125 / BW's125.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctitetorque nut to 30-35ft lbs. For reassurance please consult your manufacturer variator torque specs.

Specifications:

Include the following Compression spring.

•    1x Spring Comp: 1,000 RPM / L: 116mm
•    Spring ID: 54.5mm / OD: 58.2mm
•    Wire Gauge: 5mm
•    Made In Taiwan
•    Fit Dowel Pin Set (8x14mm)
•    Fit Belt Size: 759-22-30 (Vino)
•    Fit Belt Size: 810-22-28 (Zuma)
•    Fit Vino 125
•    Fit Zuma 125

Supported Models: NCY CVT KIT (Part# 1200-1047); Benelli Velvet 125, Italjet Millenium 125, Malaguti Madison 125, Yamaha BWS 125, Yamaha Cygnus 125, Yamaha Vino 125, Yamaha Zuma 125

-----
Item Weight & Product Dimensions:
•   0.294 Pounds | 6" (L) x 2.291" (W) x 1.909" (H)

Write a review

Note: HTML is not translated!
Bad Good
Captcha
NCY Compression Spring 1000 RPM (Vino, Zuma 125)
  • Stock: 20
  • Part #: 1200-1003
Sold: 0
Views: 2126
$14.95
Price in reward points: 15

Included