NCY Clutch Spring 2000 RPM Set (Aprilia, JOG, Zuma 50)
Description: Clutch springs do a couple of things. First, they supply the pressure to engage the clutch. They also determine the rate at which the CVT transmission changes from low to high gear along assisting the compression spring. A 1000rpm clutch spring will go into a higher gear than a 2000rpm clutch spring. Color coated identifies the strength of the clutch spring, for example, a clutch spring color coated red is identified as 2000 RPM which will delay the clutch reaction by 2000 RPM. The greater RPM spring will provide you with greater power. NCY clutch pressure spring 2000 RPM uses a modified alloy spring providing better resilience and above-average strength for Aprilia, JOG, Zuma 50, and many other 50cc base engines.
Compatible with sport clutches on the market works on Yamaha Zuma, Minarelli Jog engines, Chinese Yamaha Clones such as the 1PE40QMB 1E40QMB engines, Malaguti, CPI, as well as Aprilia Scooters with Piaggio engines, and Franco-Morini 50cc engines found in the 1E41QMB Suzuki AD50 AG50, TGB R50X, TGB 101, TGB 303 and Peirspeed Scooters.
Installation: Make sure variator drive face is seated properly and not get its teeth chewed by the Bendix: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Include the following Clutch spring set.
• 3x Clutch Springs (red): 2000 RPM / L: 31.6mm
• Spring ID: 5.4mm / OD: 9.3mm
• Wire Diameter: 1.8mm
• Made in Taiwan
• Fit Clutch Nut: M28 / Socket: 39mm
• Fit Belt Size: 818 (Fit Aprilia ONLY)
• Fit Belt Size: 788 (Fit JOG ONLY)
• Fit Belt Size: 784.5 (Fit Zuma ONLY)
• Fit Dowel Pin Set (8x10mm)
• Fit Aprilia 50
• Fit JOG 50
• Fit Zuma 50
Supported Models: NCY CVT KIT (Part# 1200-1197); Yamaha C3, Yamaha Zuma CW50, Yamaha Zuma 50F, Yamaha Vino Minarelli Jog engines, Chinese Yamaha Clones 1PE40QMB 1E40QMB engines, Malaguti, CPI, Aprilia Scooters with Piaggio engines, and Franco-Morini 50cc engines found in the 1E41QMB Suzuki AD50 AG50, TGB R50X, TGB 101, TGB 303, and Peirspeed Scooters.
Item Weight & Product Dimensions:
• 0.018 Pounds | 5.4" (L) x 3" (W) x 1" (H)