Main Menu
Your Cart

NCY Drive Face CNC-Machined Alumin (Vino, Zuma 125)

NCY Drive Face CNC-Machined Alumin (Vino, Zuma 125)
4 - 10 Days

Description: High-quality CNC machined aluminum drive face by NCY for the Yamaha Vino, Zuma 125cc scooters. The CNC-machined running surface of the disc allows for a clean, low-vibration belt operation. Not to mention its kool spectrum of silver, brass, and rose gold - color streaks!

NOTE: This is intended for show purposes/off-road use only and should not be used on a public road or highway! You are responsible for any damage this product may cause to you personally or any other objects/personal property.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctitetorque nut to 30-35ft lbs. For reassurance please consult your manufacturer variator torque specs.

Specifications:

•    Aluminum CNC Machined Anodized Drive Face 
•    Splines: 15 / ID: 14.2<16mm / OD: 117.5mm
•    Made in Taiwan
•    Fit Dowel Pin Set (8x14mm)
•    Fit Belt Size: 759x22x30 (Vino)
•    Fit Belt Size: 810x22x28 (Zuma)
•    Fit Vino 125
•    Fit Zuma 125

Supported Models: NCY CVT KIT (Part #1200-1047); Yamaha BW's 125, Yamaha Cygnus 125, Yamaha GTR 125, Yamaha Vino 125, Yamaha Zuma 125.

-----
Item Weight & Product Dimensions:
•    0.319 pounds | 4.626" (L) x 4.626" (W) x 1.496" (H)

Write a review

Note: HTML is not translated!
Bad Good
Captcha
NCY Drive Face CNC-Machined Alumin (Vino, Zuma 125)
  • Stock: 4 - 10 Days
  • Brand: NCY
  • Part #: 1200-1002
Sold: 1
Views: 137
$24.00
Price in reward points: 24

Included