NCY Drive Face Fan 115mm (GY6)

Description: Top-Shelf quality hand-made drive face 115mm by NCY for GY6 125/150cc+ engines. This drive face is a MUST when upgrading your CVT components!

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

NOTE: THIS IS NOT FOR Honda PCX (See Part# 1200-1193). GY6 engine, ankle-biter, clutch bell, and starter motor - not included, sold separately. Caution must be taken when using this product! This is intended for show purposes/off-road use only and should not be used on a public road or highway! You are responsible for any damage this product may cause to you personally or any other objects/personal property.

Specifications:

Include the following Drive face fan.

•    1x Aluminum Drive Face Fan Weight: 133.24gm / OD: 107mm<115mm / H: 18.15mm
•    Splines: 19 / ID: 13.5mm<15mm / H: 7mm
•    Made in Taiwan
•    Fit Variator Housing: 114mm or 115mm / Weights: 18x14mm / Slides: 3 / Top: 87mm / Boss: 24mm / Shims: 24mm
•    Fit Variator/Clutch Shaft Nuts: M12 / Washers: M12 / Socket: 17mm
•    Fit Belt Size: 743, 835, 842-20-30
•    Fit Dowel Pin Set (8x10mm)
•    Fit GY6 125/150cc+

Supported Models: NCY CVT KIT (Part #1200-1048); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Ruckus, Vento

-----
Item Weight & Package Dimensions:
•    0.293 pounds | 7.6" (L) x 5.48" (W) x 1.630" (H)