NCY Secondary Slider (GY6)
Description: Do you have a tuned engine that is not putting the power on the ground? NCY rear converters have aggressively angled slits to provide power where you need it and smooth transitions between belt positions with minimal hang up. The 2 different linear options mean you can give more emphasis to acceleration.
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft lbs. For reassurance please consult your manufacturer variator torque specs.
Includes the following Secondary slider (torque driver) and O-rings.
• Secondary Slider Funnel ID: 34mm / OD: 43mm / H: 47mm
• Secondary Slider Plate OD: 141.84mm
• Made in Taiwan
• Fit Dowel Pin Set (8x14mm)
• Fit Belt Size: 743, 835, 842
• Fit 54mm Stud Spacing (A-Block)
• Fit 57mm Stud Spacing (B-Block)
• Fit GY6 125/150cc+
Supported Models: NCY CVT KIT (Part# 1200-1048-1); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Ruckus, Vento
Item Weight & Product Dimensions:
• 0.969 pounds | 5.583" (L) x 1.339" (ID) x 1.85" (H)
Sorry, this video is NOT dubbed in English. Khmer speaking only.