NCY Secondary Sliding Sheave Assembly (GY6)
Description: This adjustable secondary slider plus sliding sheave from NCY will give you quicker takeoff and higher top speed. The 2 different linear options mean you can give more emphasis to acceleration.
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft lbs. For reassurance please consult your manufacturer variator torque specs.
Includes the following Secondary slider (torque driver), Sliding sheave, Spring seat, O-rings, and clutch nut.
• 1x Rear Pulley Shaft ID: 28mm / OD: 40<45mm / H: 77mm
• 1x Rear Pulley Plate OD: 141.84mm
• 3x Secondary Slider Guides
• 3x Secondary Slider Pins
• 1x Secondary Slider Funnel ID: 34mm / OD: 43mm / H: 47mm
• 1x Secondary Slider Plate OD: 141.84mm
• 1x Secondary Spring Seat/Funnel ID: 43.3mm / OD: 45mm / H: 37.20mm
• 1x Stainless Steel Clutch Nut: 39mm
• Made in Taiwan
• Fit Dowel Pin Set (8x14mm)
• Fit Belt Size: 743, 835, 842
• Fit 54mm Stud Spacing (A-Block)
• Fit 57mm Stud Spacing (B-Block)
• Fit GY6 125/150cc+
Supported Models: NCY CVT KIT (Part# 1200-1048-1); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Ruckus, Vento
Item Weight & Product Dimensions:
• 2 pounds | 5.583" (OD) x 1.339" (ID) x 3.0315" (H)
Sorry, this video is NOT dubbed in English. Khmer speaking only.