TFC Drive Face Forged +Star Him (Honda Dio)
Description: TFC Drive Face Forged aluminum plus kickstart star him for Honda DIO 50cc-90cc scooter engines. This set allows you to mount the original variator fan overlay and use TFC kickstart star him. These faces just bolt on and are lighter than stock. Most aluminum drive face strip easy in the splines or other teeth area, but these are forged strong yet lighter than stock!NOTE: THIS IS NOT FOR EARLY MODEL (PRE-1994) AF05E Engines. Must use existing variator fan overlay and nut - not included. If required, please order separately. Recommend using graphite or moly grease when assembling. Use a new belt with this kit. For Honda DIO require belt-size 654-18-30 (Part#BD44DIO-6541830).
Installation: Make sure variator drive face is seated properly and not get its teeth chewed by the bendix or variator shaft splines: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face and boss. Should be flushed together. 3. Then install existing variator fan, kick start gear, washer, and hand-tight nut. 4. Finally, torque nut to 30-35ft lbs. For reassurance please consult your manufacturer variator torque specs.
Specifications:Includes the following Drive face, Kickstart star him, and Washer.
• Forged-T6 Alumin Drive Face
• I.D: 13.5mm (Splines 19) / O.D: 114mm (Teeth 63) / H: 4.2<13.5mm
• Stainless Steel Kickstart Him w/Washer
• I.D: 13.5mm (Splines 19) / O.D: 34.32mm / H: 4<7.3mm
• Made in Taiwan
• Fit Belt Size: 654x18x30mm
• Fit DIO 50/90cc+
Supported Models: Naraku CVT KIT ECO (Part# KIT.A.139QMB.L); Honda Dio AF16 AF18E 50; Elite S/SE/SR 1994-2001, Daelim Cordi 50, Kymco Fever/ZX50, SYM DD50, and virtually any scooter engine with these measurements.
Item Weight & Package Dimensions:
• 0.3 pounds | 4.476” (OD) x 0.512” (ID) x 0.5” (H)