G- Throttle Sleeve 7/8in w/Grip (139QMB, GY6, Universal)
Description: Throttle Sleeve fits most 7/8” Throttle Sleeve include rubber grip right-side. For most scooters and motorcycles with 7/8 handlebars. Compatible with CVK and PWK carburetors.
NOTE: If throttle cable becomes dry (non-lube). Recommend use lubricating grease, oil, or WD-40 before use. This also helps ease cable friction wear and tear in throttle cable's sleeves, use lubricating tools to help grease where inner throttle sleeve and cable inside line ONLY.
Recommended use hairspray to help ease of rubber grip set slide onto the handlebar left-side and onto the throttle sleeve right-side. Hairspray will allow it to tack dray in minutes, thus allowing grip usage after 10-15 minutes applied. Or if available use an air-compressor wedge open a tiny air pocket in front of the rubber grip while pressing from behind grip to slide onto or off the handlebar and onto or off the throttle sleeve without the use of chemicals.
Include the following Right-side throttle grip.
• 1x Rt Throttle Sleeve L: 125mm (4.921”) / ID: 23mm / OD: 25.5<36.6mm
• 1x Rt Rubberized Grip L: 105mm : / ID: 25mm / OD: mm
• Fit Handlebar OD: 22mm (7/8”)
• Fit GY6
• Fit QMB
• Fit Ruckus
Supported Models: 139QMB, GY6, Honda Ruckus, Zuma, Rattler, and virtually any other scooter with these handlebar measurements.
Item Weight & Product Dimensions:
• 0.25 pounds | 4.921" (L) x 0.906" (ID) x 1.441" (OD)
From Same Category
- Stock: 38
- Part #: 0800-4005