Main Menu
Your Cart

Buzzetti Variator Lock Bracket (Metro, Ruckus GET)

Buzzetti Variator Lock Bracket (Metro, Ruckus GET)
Buzzetti Variator Lock Bracket (Metro, Ruckus GET)
Buzzetti Variator Lock Bracket (Metro, Ruckus GET)
Buzzetti Variator Lock Bracket (Metro, Ruckus GET)

Description: Buzzetti Variator Lock Bracket Tool. This simple yet effective tool for Metropolitan, Honda Ruckus 4-Stroke makes installation and removal of the variator super easy. Buzzetti Variator Lock Bracket Tool does it by locking into place the variator‘s teeth. Thus, stop the variator from spinning freely. Once the variator is lock from spinning freely, you can easily remove the variator nut to remove the entire variator components drive face, boss, roller weight, etc. When finish tuning or upgrading variator components just securely re-tight with a torque wrench and remove Naraku Variator Lock Bracket by its two screws and you and your variator will be spinning freely again!

NOTE: Recommend using a new belt with any new CVT kit. Belt and the belt drive-facing plates KEEP DRY. All, other areas apply moly-graphite grease when assembling.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctitetorque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

Includes the following variator Lock bracket and Bolt set.

•    1x Bracket (brass) L: 180.34mm / W: 40mm / H: 14.43mm  
•    2x Allen Screws: M6x26mm 
•    2x Hex Nuts: M6x5mm
•    Material: Metal
•    Made in Italy
•    Fit Variator Housing: 95mm Weights: 16x13mm / Slides: 3 Boss: 20mm / Shims: 20mm / Drive Spline: 26
    Fit Variator Shaft Nut: M12 / Washer: M12 / Socket: 17mm
•    Fit Belt Size: 660-18-28 (Fit Metro ONLY)
•    Fit Belt Size: 785-18-30 (Fit Ruckus ONLY)
•    Fit Dowel Pin Set (8x10mm)
•    Fit GET 49/50cc

Supported Models: NCY CVT Kit (Part# 1200-1220); Metropolitan GET 2012 & older, Honda Ruckus GET all U.S. models, Zoomer 50cc, and virtually any scooter engine with these measurements.

-----
Item Weight & Product Dimensions:
•    0.45 Pounds | 7.1” (L) 1.584” (W) 1.572” (H) 1"

Write a review

Note: HTML is not translated!
Bad Good
Captcha
Buzzetti Variator Lock Bracket (Metro, Ruckus GET)
  • Stock: 39
  • Reward Points: 1
  • Part #: 166-1
Sold: 1
Views: 9781
$24.99
Price in reward points: 25

Included