Stage6 Compression Spring Hard (Aprilia, Piaggio, Vespa 50)
Description: Stage6 Compression Spring Hard for Aprilia, Piaggio 50, Vespa 2-stroke engines. These black-coated torque springs from Stage6 are available in different strengths. Due to tuning, the drive belt may start to slip, which will make a stronger torque spring necessary. You will usually notice that the engine revs up but you can't feel any acceleration. The strength of a torque spring is marked on the spring itself so you won't have any problems identifying it. Dimensions: 4.3 x 58.1 mm
Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.
Include the following Compression spring.
• 1x Hard Spring Comp: RPM / L: mm
• Spring ID: mm / OD: mm
• Wire Gauge: mm
• Made in Italy
• Fit Aprilia 49/50cc
• Fit Piaggio 49/50cc
• Fit Vespa 49/50cc
Supported Models: Aprilia Mojito 50, Aprilia SR 50 Funmaster LC, Aprilia SR 50 LC, Aprilia SR 50 Racing, Aprilia Scarabeo 50 AC, Aprilia Sportcity Street 50, Derbi Atlantis 50 AC, Derbi Bullet 50 AC, Derbi GP150 LC, Derbi GP10pen 50, Gilera DNA 50 LC, Gilera Ice 50 AC, Giler Runner 50, Gilera Stalker 50, Gilera Storm 50, giler Typhoon 50, Italjet Torpedo 50 AC, Piaggio Fly 50 AC, Piaggio NRG 50 LC, Piaggio Storm 50, Piaggio Typhoon 50 AC, Piaggio Vespa S 50, Piaggio Zip Base 50, Vespa ET2 50 AC ZAPC 16000, Vespa LX 50 AC 2-Stroke, Vespa LXV 50 2-stroke AC, Vespa Primavera 50 2T, and virtually any other scooter engine with these measurements.
Item Weight & Product Dimensions:
• 0.212 Pounds | 4.173" (L) x 2.291" (W) x 1.909" (H)