Main Menu
Your Cart

NCY Secondary Sliding Sheave Shaft (GY6)

NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)
NCY Secondary Sliding Sheave Shaft (GY6)

Description: NCY Secondary Sliding Sheave Shaft for use in GY6 125cc-150cc+ 4-stroke engines.

NOTE: THIS IS NOT FOR Honda PCX (See Part# 1200-1034). Recommend using a new belt with this kit. Belt and the belt drive-facing plates KEEP DRY. All, other areas apply moly-graphite grease when assembling. Example, lubricate slider grooves, slider pins, ball bearing seat, and inner funnel area with heat-resistant moly-graphite grease.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctitetorque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

Includes the following Sliding sheave, and clutch nut.

•    1x Rear Pulley Plate OD: 141.84mm / Shaft ID: 28mm / OD: 40<45mm / H: 77mm
•    1x Stainless Steel Clutch Nut: M28
•    Made in Taiwan
    Fit Clutch: 121.8mm / Shaft: 174mm Pins: 6mm / Nut: M12 / Washer: M12 / Bearing Funnel43mm / Bell Spline: 19 / Socket: 17mm19mm39mm
•    Fit Compression Spring: 1k1.5k2k rpm
•    Fit Clutch Springs: 1k1.5k2k rpm
•    Fit Belt Size: 743835842-20-30
•    Fit Dowel Pin Set (8x10mm)
•    Fit GY6 125/150cc+

Supported Models: NCY CVT KIT (Part# 1200-1048); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Ruckus, Vento

-----
Item Weight & Product Dimensions:
•    1.381 pounds | 5.584" (OD) x 0.803" (ID) x 3.210" (H)

Write a review

Note: HTML is not translated!
Bad Good
Captcha
NCY Secondary Sliding Sheave Shaft (GY6)
  • Stock: 40
  • Reward Points: 2
  • Part #: 1200-1198-S
Sold: 0
Views: 170
$62.00
Price in reward points: 62

Included