TFC Secondary Sliding Sheave Forged Assembly (GY6)

Description: TFC Secondary Sliding Sheave Forged Assembly for GY6 125\150cc 4-stoke engines. This adjustable secondary slider plus sliding sheave from TFC will give you quicker takeoff and higher top speed with its light forged aluminum rear pully plates and two different linear options mean you can give more emphasis to acceleration without the extra rear pulley weight.

NOTE: Recommend using a new belt with this kit. Belt and the belt drive-facing plates KEEP DRY. All, other areas apply moly-graphite grease when assembling. Example, lubricate slider grooves, slider pins, ball bearing seat, and inner funnel area with heat-resistant moly-graphite grease.

Installation: 1. Slack the belt by opening the CVT clutch gives belt slack to the variator side. 2. Then install the variator drive face while lifting the slack belt further away from the center boss if done properly should not see any splines between variator drive face slop-side and boss flat-side. Should be flushed together. 3. Then install the existing variator fan, washer, and hand-tight nut. 4. Finally, apply blue Loctite, torque nut to 30-35ft-lbs. For reassurance please consult your manufacturer's variator torque specs.

Specifications:

Includes the following Secondary slider (torque driver), Sliding sheave, Spring seat, O-rings, and Clutch nut.

•    1x Forged Alumin Rear Pulley Plate OD: 141.84mm / Shaft ID: 28mm / OD: 40<45mm / H: 77mm
•    1x Forged Alumin Secondary Slider Plate OD: 141.84mm / Funnel ID: 34mm / OD: 43mm / H: 47mm
•    1x Metal Secondary Spring Seat/Funnel ID: 43.3mm / OD: 45mm / H: 37.20mm
•    3x Steel Secondary Slider Guides ID: 6mm / OD: 9.7mm / L: 3.3mm
•    3x Steel Secondary Slider Pins OD: 5.9<8.5mm / H: 9.1mm
•    1x Stainless Steel Clutch Nut: M28
•    2x Rubber O-rings (pre-installed)
•    Made in Taiwan
•    Fit Clutch: 120mm / Shaft: 174mm / Nut: M12 / Washer: M12 / Bearing Funnel: 43mm / Bell Spline: 19 / Socket: 17mm, 19mm, 39mm
•    Fit Compression Spring: 1k, 1.5k, 2k rpm
•    Fit Clutch Springs: 1k, 1.5k, 2k rpm
•    Fit Belt Size: 743, 835, 842-20-30
•    Fit Dowel Pin Set (8x10mm)
•    Fit GY6 125/150cc+

Supported Models: TFC CVT KIT (Part# TFC-012); GY6 152QMI 157QMJ 161QMK 161QML Chinese Scooter, ATV, Genuine Buddy, Kymco, Polaris RZR 170, Ruckus, Vento

-----
Item Weight & Product Dimensions:
•    1.887 pounds | 5.583" (OD) x 1.339" (ID) x 3.0315" (H)

Sorry, this video is NOT dubbed in English. Khmer speaking only.